3D printing of classic car parts can very usefull for the so called "end of life parts". Producing it the traditional way is often to expensive and 3D printng can be the solution.

For eample: the turnsignal housings are made of Zamac and it desintegrates during the years. Reproducing it the traditional way is way to expensive. We reproduced them however, not the traditional way but we have them printed by  a professional company.

3D printing at this moment has it limitations. Only small parts can be printed (up to 30 cm) and the surface finish is expensive. Chrome painting is possible but expensive.

If you have any parts you want to have 3D printed, then email me. 

 

 

Sort by:  

Door handle gasgets, New. Door handle gaskets left or right side. You get the larger…
€ 17,50
Plastic parts Horn Switch Only at Taunusparts.com. 3D nylon printed parts for the horn…
€ 28,00
3D printed P5 HT emblem 3D printed HT emblem. Surface treatment depends on what you…
€ 0,00
Carb acceleration diagram operation pin V4 engine Reproduction.Part number 6234050. Fits Fomoco Carb German…
€ 24,95
Alustrip connecting pieces (4) This is a piece of 20cm, long so you can make 4 pieces of…
€ 19,00
P6 New turn signal housings! Now available, new turn signal housings (left or right) NEW…
€ 58,00
P5 Now available: new turn signal housings! 59 euro piece. Order a set (left and right) and pay only 110…
€ 59,00
Taunus Keychain I received the Taunus keychains from the print factory…
€ 12,99
Potentiometer end cap ready to order! Received it today form the print factory and I am very…
€ 18,50